Metal Lift Kits for Motormax 2019 1/24 GMC Sierra scale diecast model

This Lift kit is specifically made for MotorMax 1/24 scale 2019 GMC Sierra
Please note, the lift kit takes 15-20 mins to install. Difficulty level: 2/10
- 4x Adjustable Waterproof Lift kits
- Fully metal
- includes spacers
- INCLUDES Black or Chrome 1" 1/2 WHEELS/TIRES/AXLES
- Comes with a mini screw driver to tighten the nuts and bolt
Materials needed to install:
Mini screw driver and mini wrench (included)
Drill (for drilling into the car frame) (see last pic for details) (drill/bit not included)
Manual Instructions:
1. Take your drill bit that’s the same size as the metal lift kits hole.
2. Drill below your wheel well into an accurate spot to place lift. (See pictures)
3. After 1st hole has been drilled, **make sure all other holes are even on both Front sides. Otherwise your truck will look lopsided when finished** Make sure the rear Lift is drilled in the center or the rear frame.
4. Mark your holes before you cut any other sides.
5. After you’ve finished drilling the holes on all the sides, take your lift kit and (just as according to the closeup picture) Take the screw on the top of the lift kit and place it into your drilled hole and then tighten each accordingly.
6. After all sides are screwed on, please note that you will need an axle long enough (approximately 2” for your wheels to slide through the bottom wheel placement.
Lift can fit up to 1” 1/2 wheel size (diameter) (Wheels/tires included)
Lift raises the truck about 7/8” from the wheel well.